1996 Toyota Tercel EGR valve question
l just had my EGR valve cleaned and the tube running to the manifold,the
check engine light came back on and it is idling a little rough again.l
tested the valde by pressing on the diaphram with my finger and it did not
kill the engine.Is it still possible it could be a solinoid or one of the
hoses going to the EGR are clogged still or should l just get the whole
EGR assembly replaced? The only reason the engine light went off orginally is because the mechanic reset the code.
the mechanic reset the codes ,and run the engine to see if they
pop out again,that didn't happen. and now ,chances are that the egr is
still dirty.
( may be has never been cleaned!! . I know my people.)
I haven't worked on cars since the 1970's..
But there is also a AIR PUMP that is connected..
..from my experiance..the AIR PUMP can seize up--actually making its
BELT--squeal..and then break..
That is about all I can offer.
Business VOIP VOIP NFL Tickets For Sale
5 posts
• Page 1 of 1
97 vortec gmc, if it has a bad intake manifold gasket will it result in high rpms at idle and vac. in the valv What differs an engine with a same cubic capacity but producing different HP and Torque.? EGR Valve flow 1999 mercury mountaineer with emission problem Where is my canister purge valve What problems could be cause by a cracked PCV vacuum hose? could a ported 3.7l 40 valve v8 match or outflow a 7.0l 16 valve v8 with or without boost I currently have a SOHC non-vtec 1.5L 16 valve andddd Manifold Heating up - 94 chevy tracker how much does it cost to put a turbo on coolant inside oil means blown head gasket, could it also come from a leaky intake manifold??? Why does my small engine have such advanced idle control? pcv valve hose connection What does the oil seperator do? PCV valve?? Who is onlineUsers browsing this forum: 4 guests |